A lot of grey paint was applied today to the frame along the back of the bus and down the offside towards the emergency door, including the pillar repaired yesterday.
Whilst the grey paint dried I drilled the cross bearers and pillars for new bolts to fix the gusset plates, adding a few extra bolt holes to increase the strength of the joints. Next I cut out and drilled the rest of the gusset plates. These need deburring and painting then they can be fitted.
The next major task will be fitting the new steel bulkhead to the front of the boot.
Today I was able to install the pillar repair section I made yesterday. Screwed and glued to both the existing remnant of upright and to the boot floor cross bearer and given a coat of primer.
Whilst that was drying I installed the two new gusset plates for the previous pillar repair and bolted them up to the cross bearer and upright.
Finally I made a couple of brackets to reinforce the joint between today’s new section of pillar and the existing part. These will also connect to the horizontal that joins the vertical at this point.
I now need to make up the gussets for this new piece before I can fix the new perimeter rail section at the bottom of the pillars.
This morning I painted a coat of grey onto the new timber on the RH side of the boot door frame and the steel frame that links this to the corner pillar, ready for the corner timber to be fitted. I also spray painted the two gusset plates for this section so this can all be assembled now.
Whilst the paint was drying I cut away the next rotten pillar down the OS and made a replacement. This is also ready for fitting, probably the first job tomorrow as the rest can be done whilst the glue sets.
Restoration diary of a 70-year old AEC single-deck bus and the trials, tribulations and adventures of our 1966 Bristol bus.
